Title: Fiber Optic Splice Closure Pigtail Cost And Performance Trade-Offs
Blog Entry: Fiber Optic Splice Closure Pigtail Cost And Performance Trade-Offs In any fiber optic cable installation, the manner in which the cable is connected to the system, whether at the entrance to the building, in the wiring closet, or at the point between the transmitter and the receiver, is critical to the success of the telecommunications network. If done well, this connection allows the optical signal to pass with low attenuation and low return loss. One proven method of connecting fibers is to use Fiber Optic Splice Closure pigtails with a factory-installed connector on one end and unterminated fiber on the other end. Fiber Optic Splice Closure bridges critical connection points in fiber optic networks, so installers need to choose products that are made with reliable components. Because they are basically cable assemblies, the pigtails use the same components familiar to many experienced fiber optic technicians, such as connectors, ferrules, standard fiber and jacket types, including single-mode and multi-mode varieties. While each of these components is important, one of them stands out. An important factor is the quality of the connector itself. You need to understand certain characteristics such as insertion loss, the type of polishing used, and the extent to which the connector is terminated to the cable. " Even with standards, there are significant differences between connector styles and manufacturers. Therefore, you must use fiber and connector types that meet your specific application needs. Choosing the right product depends on the job specifications. When ordering fiber pigtails, the ferrule material must also be specified, whether it is zirconia ceramic, plastic or stainless steel. Recently, ceramic ferrules are the main ferrule material on the market, and when it comes to other ferrule materials, cost/performance trade-offs are not tolerable. If you use metal ferrules, it's a waste for any single-mode application, especially if you need Bellcore compatibility. Fiber manufacturers should also be considered. The main concern is the use of the same glass in fiber pigtails and fiber optic cables. Because this is one of the key factors that determine the performance of the entire fiber system. The information about Fiber Optic Splice Closure :